Removal

4GR-FSE CHARGING: GENERATOR: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM SIDE COVER LH Removal

4. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

5. REMOVE NO. 1 INLET AIR CLEANER Removal

6. REMOVE V-RIBBED BELT Removal

7. DRAIN ENGINE COOLANT Testing and Inspection

8. REMOVE RADIATOR INLET HOSE Removal

9. REMOVE NO. 2 ENGINE COVER Removal

10. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY Removal

11. DISCONNECT WIRE HARNESS

(a) Remove the 3 nuts (A) and disconnect the wire harness.





(b) Disconnect the 2 connectors (B).

12. REMOVE GENERATOR ASSEMBLY

(a) Remove the terminal cap.





(b) Remove the nut (A) and disconnect the wire harness from the terminal B.

(c) Remove the bolt (B) and clamp bracket.

(d) Disconnect the generator connector, and detach the 2 clamps.

(e) Remove the nut, and disconnect the generator bracket.





(f) Remove the 2 bolts and generator.





(g) Remove the 2 bolts and 2 generator brackets.