Dynamic Radar Cruise Control System

CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: U0235: Lost Communication with Cruise Control Front Distance Range Sensor
U0235 - Lost Communication with Cruise Control Front Distance Range Sensor

DESCRIPTION

The millimeter wave radar sensor assembly and distance control ECU transmit the data for general vehicle control and diagnosis function using communication lines. The millimeter wave radar sensor assembly transmits information about the vehicle in front to the distance control ECU.





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* When the distance control ECU is replaced with a new one, initialization must be performed Installation.
* When the millimeter wave radar sensor is replaced with a new one, adjustment of the millimeter wave radar sensor assembly beam axis must be performed Adjustments.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - MILLIMETER WAVE RADAR SENSOR ASSEMBLY)

(a) Disconnect the distance control ECU connector.





(b) Disconnect the millimeter wave radar sensor assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):





Standard Resistance (Check for Short):





Text in Illustration





(d) Reconnect the distance control ECU connector.

(e) Reconnect the millimeter wave radar sensor assembly connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (DISTANCE CONTROL ECU - MILLIMETER WAVE RADAR SENSOR ASSEMBLY)
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (MILLIMETER WAVE RADAR SENSOR ASSEMBLY - BODY GROUND)

(a) Disconnect the millimeter wave radar sensor assembly connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):





Text in Illustration





(c) Reconnect the millimeter wave radar sensor assembly connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (MILLIMETER WAVE RADAR SENSOR ASSEMBLY - BODY GROUND)
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - BODY GROUND)

(a) Disconnect the distance control ECU connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):





Text in Illustration





(c) Reconnect the distance control ECU connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (DISTANCE CONTROL ECU - BODY GROUND)
OK -- Continue to next step.

4. CHECK DISTANCE CONTROL ECU

(a) Turn the engine switch on (IG).





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





NG -- REPLACE DISTANCE CONTROL ECU Removal
OK -- Continue to next step.

5. REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

(a) Replace the millimeter wave radar sensor assembly Removal.

(b) Adjust the millimeter wave radar sensor assembly Adjustments.

NEXT -- Continue to next step.

6. CHECK WHETHER DTC OUTPUT RECURS (DTC U0235)

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Clear the DTCs Dynamic Radar Cruise Control System.

(e) Perform the following to make sure that the DTC detection conditions are met.

HINT
If the detection conditions are not met, the malfunction cannot be detected.

(1) Drive the vehicle at a speed of 50 km/h (30 mph) or more.

(2) Turn the cruise control main switch on.

(f) Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.

(g) Read the DTCs Dynamic Radar Cruise Control System.

Result:





B -- REPLACE DISTANCE CONTROL ECU Removal

A -- END