Inspection

RA62 MANUAL TRANSMISSION / TRANSAXLE: MANUAL TRANSMISSION UNIT: INSPECTION

1. INSPECT REVERSE IDLER GEAR THRUST CLEARANCE

(a) Using a feeler gauge, measure the thrust clearance.





Standard clearance:

0.130 to 0.214 mm (0.00512 to 0.00842 in.)

Maximum clearance:

0.214 (0.00842 in.)

If the clearance exceeds the maximum, replace the reverse idler gear shaft, reverse idler gear or front transmission case during reassembly.

2. INSPECT REVERSE IDLER GEAR RADIAL CLEARANCE

(a) Install the reverse idler gear and reverse idler gear bearing to the reverse idler gear shaft.





(b) Using a dial indicator, measure the radial clearance.

Standard clearance:

0.015 to 0.050 mm (0.000591 to 0.00197 in.)

Maximum clearance:

0.050 mm (0.00197 in.)

If the clearance exceeds the maximum, replace the reverse idler gear bearing, reverse idler gear shaft or reverse idler gear during reassembly.