Installation

WIPER / WASHER: RAIN SENSOR: INSTALLATION

1. INSTALL RAIN SENSOR TAPE

HINT
Rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.

(a) Clean the rain sensor sensing portion with a piece of cloth, etc.

(b) Peel off the releasing sheet (yellow side) and attach the rain sensor tape on the position indicated in the illustration (the sensor part of the rain sensor) while pushing out air bubbles with fingers.





Standard Clearance





Text in Illustration





(c) Peel off the releasing sheet (white side).

NOTICE:
Do not touch the sensor tape surface directly with fingers.

2. INSTALL RAIN SENSOR

(a) Connect the connector.

(b) Engage the bracket as shown in the illustration to set the position.





Text in Illustration





(c) Gradually attach the rain sensor to the glass surface to prevent air bubbles from forming in between them.

(d) Push in the stopper.





Text in Illustration





NOTICE:
After installing the rain sensor, there should be no air bubbles between the windshield glass and the rain sensor tape.