Removal
SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing Service Precautions.
NOTICE:
w/ Navigation System for HDD:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission) Removal
4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission) Removal
5. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission) Removal
6. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission) Removal
7. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission) Removal
8. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Removal
9. REMOVE FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Removal
10. REMOVE INSTRUMENT PANEL COIN BOX (w/o Ashtray) Removal
11. REMOVE FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray) Removal
12. REMOVE REAR ASH RECEPTACLE ASSEMBLY (w/ Ashtray) Removal
13. REMOVE CONSOLE BOX REGISTER ASSEMBLY (w/o Ashtray) Removal
14. REMOVE CONSOLE BOX REGISTER ASSEMBLY (w/ Ashtray) Removal
15. REMOVE CONSOLE BOX Removal
16. REMOVE CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect the connectors from the center airbag sensor assembly as shown in the illustration.
NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
(d) Remove the 2 bolts, nut and center airbag sensor assembly.