Removal

NAVIGATION / MULTI INFO DISPLAY: HARD DISK DRIVE: REMOVAL

1. PRECAUTION

NOTICE:
* After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
* A hard disk drive (HDD) is built into the display and navigation module display (HDD navigation system) to store map data etc. which will be used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the display and navigation module display (HDD navigation system).
* When replaced the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

4. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH Removal

5. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Removal

6. REMOVE CONSOLE PANEL SUB-ASSEMBLY Removal

7. REMOVE INSTRUMENT PANEL BOX ASSEMBLY (w/o Ashtray) Removal

8. REMOVE FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray) Removal

9. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

10. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Removal

11. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY WITH RADIO RECEIVER ASSEMBLY Removal

12. REMOVE HARD DISK DRIVE

(a) Remove the 2 screws.





(b) Using a screwdriver with its tip taped with protective tape, slide the hard disk drive in the direction shown by the arrow to remove it.





Text in Illustration