Operation CHARM: Car repair manuals for everyone.

Removal





EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL

(a) Using a clip remover, remove the 9 clips and cool air intake duct seal.





2. REMOVE RADIATOR GRILLE PROTECTOR

(a) Remove the 2 radiator grille protectors.





3. REMOVE FRONT BUMPER ASSEMBLY

(a) Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.





HINT
* Tape the screwdriver tip before use.
* Use the same procedure for the RH side and LH side.

(b) remove the screw.





HINT
Use the same procedure for the RH side and LH side.

(c) Put protective tape around the front bumper assembly.





(d) Remove the 8 screws.

(e) Using a clip remover, remove the 2 clips and screw.





(f) Disengage the 10 claws and disconnect the front bumper assembly as shown in the illustration.





(g) w/ headlight cleaner system:

(1) Disconnect the headlight cleaner hose.

NOTICE:
Prepare a drain pan or a piece of cloth in case washer fluid leaks.

(h) w/ intuitive parking assist system:

(1) Disconnect the ultrasonic sensor connector.

(i) Disconnect the 2 fog light connectors and remove the front bumper assembly.