Installation
2UR-GSE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION
1. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH
(a) Install a new gasket.
(b) Install the exhaust manifold sub-assembly LH, and install 8 new nuts in the order shown in the illustration.
LH:
Torque : 21 Nm (214 kgf-cm, 16 ft-lbf)
2. INSTALL AIR FUEL RATIO SENSOR Installation
3. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
(a) Install the exhaust manifold heat insulator with the 3 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Connect the air fuel ratio sensor connector.
4. INSTALL ENGINE MOUNTING DAMPER
(a) Install the engine mounting damper with the bolt.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
5. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
(a) Install a new gasket.
(b) Install the exhaust manifold sub-assembly RH, and install 8 new nuts in the order shown in the illustration.
RH:
Torque : 21 Nm (214 kgf-cm, 16 ft-lbf)
6. INSTALL AIR FUEL RATIO SENSOR Installation
7. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
(a) Install the No. 1 exhaust manifold heat insulator with the 3 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Connect the air fuel ratio sensor connector.
8. INSTALL OIL LEVEL DIPSTICK GUIDE SUB-ASSEMBLY
(a) Apply engine oil to a new O-ring, and install it to the oil level dipstick guide sub-assembly.
(b) Install the oil level dipstick guide sub-assembly with the bolt.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
9. INSTALL OIL LEVEL DIPSTICK SUB-ASSEMBLY
(a) Install the oil level dipstick sub-assembly.
10. INSTALL ENGINE ASSEMBLY WITH TRANSMISSION
Installation