Removal

2UR-GSE INTAKE / EXHAUST: EXHAUST PIPE: REMOVAL

CAUTION:
* Wear protective gloves when removing the exhaust pipe.
* The exhaust pipe is extremely hot immediately after the engine has stopped.
* Confirm that the exhaust pipe has cooled down before removing it.
1. REMOVE TAIL EXHAUST PIPE ASSEMBLY

(a) Remove the 2 bolts and 2 compression springs.





(b) Remove the tail exhaust pipe assembly from the 6 exhaust pipe supports.

(c) Remove the gasket from the front exhaust pipe assembly.

2. REMOVE EXHAUST PIPE DAMPER

(a) Remove the 2 bolts and damper.





3. REMOVE NO. 1 FLOOR UNDER COVER

4. REMOVE NO. 2 FLOOR UNDER COVER

5. REMOVE REAR NO. 1 FLOOR PANEL BRACE

(a) Remove the 4 bolts and rear No. 1 floor panel brace.





6. REMOVE FRONT CENTER FLOOR BRACE

(a) Remove the 4 bolts and front center floor brace.





7. DISCONNECT HEATED OXYGEN SENSOR

(a) Remove the grommets of the heated oxygen sensors.





(b) Using SST, loosen the heated oxygen sensors, and disconnect the sensors by hand.





SST : 09224-00010

8. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(a) Remove the 4 bolts, 4 nuts and front exhaust pipe assembly.





(b) Remove the 2 gaskets from the exhaust manifold RH and exhaust manifold LH.