Diagnosis System
NETWORKING: CAN COMMUNICATION SYSTEM: DIAGNOSIS SYSTEM
1. CAN BUS CHECK
(a) Using the Techstream, select "CAN Bus Check" from the "System Select".
2. CHECK FOR INSTALLED SYSTEMS (ECUS AND SENSORS) THAT ADOPT CAN COMMUNICATION
(a) Systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle optional settings. Check which systems (ECUs, sensors) are installed on the vehicle.
3. DTC TABLE BY ECU
HINT
If CAN communication system DTCs are output, trouble cannot be determined only by the DTCs. Perform troubleshooting according to "How to Proceed with Troubleshooting" How to Proceed With Troubleshooting. (If however, U0235 or U01102 is output alone, see the dynamic radar cruise control system.)
(a) ECM/Techstream display "Engine"
HINT
* DTC communication uses the CAN communication system.
* Distance control ECU data is also output.
* *1: The ECM is malfunctioning if U0101 is output. Replace the ECM.
* *2: If U0235 or U1102 is output alone, the CAN communication is normal Dynamic Radar Cruise Control System for U0235, Dynamic Radar Cruise Control System for U1102).
* *3: Dynamic radar cruise DTC
(b) ECM/Techstream display "ECT"
HINT
* DTC communication uses the CAN communication system.
* *1: The ECM is malfunctioning if U0100 is output. Replace the ECM.
(c) SKID CONTROL ECU/Techstream display "ABS/VSC/TRAC"
HINT
DTC communication uses the CAN communication system.
(d) POWER STEERING ECU/Techstream display "EPS"
HINT
DTC communication uses the CAN communication system.
(e) SEAT BELT CONTROL ECU/Techstream display "Pre-Collision 1"
HINT
DTC communication uses the CAN communication system.
(f) DISPLAY AND NAVIGATION MODULE DISPLAY/Techstream display "Display and Navigation (AVN1)"
HINT
DTC communication uses the CAN communication system.
(g) GATEWAY ECU
HINT
The gateway ECU is connected to the CAN communication system, but CAN communication DTCs are not output.
(h) CENTER AIRBAG SENSOR
HINT
The center airbag sensor is connected to the CAN communication system, but CAN communication DTCs are not output.
(i) STEERING ANGLE SENSOR
HINT
The steering angle sensor is connected to the CAN communication system, but CAN communication DTCs are not output.
(j) YAW RATE SENSOR
HINT
The yaw rate sensor is connected to the CAN communication system, but CAN communication DTCs are not output.
4. DTC COMBINATION TABLE
HINT
* o: Set
* X: Not set or may be set according to the malfunction part when one side of the CAN branch line opens.
* [Square]: Set under the condition shown in the table.
* *1: Does not output it during communication error
* Skid Control ECU Communication Stop Mode: Skid Control ECU Communication Stop Mode
* Steering Angle Sensor Communication Stop Mode: Steering Angle Sensor Communication Stop Mode
* Yaw Rate Sensor Communication Stop Mode: Yaw Rate Sensor Communication Stop Mode
* Gateway ECU Communication Stop Mode: Gateway ECU Communication Stop Mode
* ECM Communication Stop Mode: ECM Communication Stop Mode
* Distance Control ECU Communication Stop Mode: Distance Control ECU Communication Stop Mode
* Seat Belt Control ECU Communication Stop Mode: Seat Belt Control ECU Communication Stop Mode
* Power Steering ECU Communication Stop Mode: Power Steering ECU Communication Stop Mode
* Center Airbag sensor Communication Stop Mode: Center Airbag Sensor Communication Stop Mode
* Navigation ECU Communication Stop Mode: Navigation ECU Communication Stop Mode