Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL

1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

4. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH Removal

5. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Removal

6. REMOVE CONSOLE PANEL SUB-ASSEMBLY Removal

7. REMOVE INSTRUMENT PANEL BOX ASSEMBLY (w/o Ashtray) Removal

8. REMOVE FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray) Removal

9. REMOVE REAR ASH RECEPTACLE ASSEMBLY (w/ Ashtray) Removal

10. REMOVE CONSOLE BOX REGISTER ASSEMBLY (w/o Ashtray) Removal

11. REMOVE CONSOLE BOX REGISTER ASSEMBLY (w/ Ashtray) Removal

12. REMOVE CONSOLE BOX Removal

13. REMOVE CENTER AIRBAG SENSOR ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Disconnect the holder (with connectors).





NOTICE:
When disconnecting the airbag connector, take care not to damage the airbag wire harness.

(d) Remove the 2 bolts, nut and center airbag sensor assembly.