Installation
FRONT SUSPENSION: FRONT LOWER SUSPENSION ARM: INSTALLATION
HINT
* Use the same procedure for the LH side and RH side.
* The following procedure listed is for the LH side.
1. TEMPORARILY TIGHTEN NO. 2 LOWER ARM BRACKET ASSEMBLY
(a) Temporarily install the No. 2 lower arm bracket assembly to the front lower suspension arm with the nut and washer.
2. TEMPORARILY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY
(a) Install the front lower suspension arm assembly and side rail plate with the 4 bolts and the nut.
Bolt 1 - Torque : 188 Nm (1917 kgf-cm, 138 ft-lbf)
Bolt 2 - Torque : 86 Nm (877 kgf-cm, 63 ft-lbf)
Bolt 3 - Torque : 50 Nm (510 kgf-cm, 37 ft-lbf)
(b) Temporarily tighten the front lower suspension arm with the bolt, washer, and nut.
HINT
Insert the bolt from the front of the vehicle.
3. INSTALL FRONT LOWER BALL JOINT Installation
4. TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
(a) Insert the bolt from the rear of the vehicle, and install the front shock absorber lower side on the front lower suspension arm.
(b) Temporarily tighten a nut while holding the bolt.
5. INSTALL STEERING KNUCKLE WITH AXLE ASSEMBLY Installation
6. INSTALL FRONT DISC Installation
7. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY Installation
8. INSTALL FRONT STABILIZER LINK ASSEMBLY Installation
9. CONNECT FRONT SPEED SENSOR Installation
10. STABILIZE SUSPENSION Installation
11. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
(a) Fully tighten the bolt on the lower side of the front shock absorber while holding the nut.
Torque : 157 Nm (1601 kgf-cm, 116 ft-lbf)
12. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY
(a) Fully tighten the bolt on the front of the front lower suspension arm assembly.
Torque : 135 Nm (1377 kgf-cm, 100 ft-lbf)
(b) Fully tighten the installation nut of the No. 2 lower arm bracket assembly.
Torque : 113 Nm (1152 kgf-cm, 83 ft-lbf)
13. INSTALL NO.2 ENGINE UNDER COVER
14. INSTALL ENGINE UNDER COVER
15. INSTALL FRONT WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
16. CHECK FOR SPEED SENSOR SIGNAL
HINT
Check for speed sensor signal. Test Mode Procedure
17. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT
Inspect and adjust the front wheel alignment. Front Wheel Alignment