Installation

AA80E AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: INSTALLATION

1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

(a) Install the floor shift assembly with the 4 bolts.





Torque : 8.3 Nm (85 kgf-cm, 73 in-lbf)

(b) Connect the 4 clamps to the floor shift assembly.

(c) Connect the 2 connectors to the floor shift assembly.

2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

(a) Temporarily tighten the floor shift gear shifting rod with the nut.





HINT
The rod is tightened to a torque specification in the "ADJUST SHIFT LEVER POSITION" procedure.

3. ADJUST SHIFT LEVER POSITION Adjustments

4. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR Installation

5. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

6. CONNECT HEATED OXYGEN SENSOR Installation

7. INSTALL FRONT CENTER FLOOR BRACE Installation

8. INSTALL REAR NO. 1 FLOOR PANEL BRACE Installation

9. INSTALL TAIL EXHAUST PIPE ASSEMBLY Installation

10. INSTALL NO. 2 FLOOR UNDER COVER Installation

11. INSTALL NO. 1 FLOOR UNDER COVER Installation

12. INSTALL NO. 2 CONSOLE BOX DUCT Installation

13. INSTALL CONSOLE BOX Installation

14. INSTALL CONSOLE BOX REGISTER ASSEMBLY (w/ Ashtray) Installation

15. INSTALL CONSOLE BOX REGISTER ASSEMBLY (w/o Ashtray) Installation

16. INSTALL REAR ASH RECEPTACLE ASSEMBLY (w/ Ashtray) Installation

17. INSTALL FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray) Installation

18. INSTALL INSTRUMENT PANEL BOX ASSEMBLY (w/o Ashtray) Installation

19. INSTALL CONSOLE PANEL SUB-ASSEMBLY Installation

20. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH Installation

21. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH Installation

22. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

23. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

24. INSPECT SHIFT LEVER POSITION Initial Inspection and Diagnostic Overview

25. INSPECT FOR EXHAUST GAS LEAK