P0A80

HYBRID BATTERY CONTROL: HYBRID BATTERY SYSTEM: P0A80-123: Replace Hybrid Battery Pack
P0A80-123 - Replace Hybrid Battery Pack

DESCRIPTION

The hybrid vehicle control ECU controls the SOC (state of charge) of the HV battery at a constant level while driving. The HV battery is composed of 20 modules, and each module consists of 12 1.2 V cells in series. The battery smart unit monitors the battery block voltage at 20 locations.









HINT
This DTC cannot be set unless the vehicle is driven for approximately 10 minutes after clearing the DTCs. Two trip detection logic is used. After the first road test, turn the power switch off and perform a road test again.

MONITOR DESCRIPTION

The battery smart unit, which monitors the voltage of the battery blocks, determines that a malfunction has occurred if a voltage difference between the battery blocks exceeds the standard. When the malfunction detection condition is satisfied, the hybrid vehicle control ECU illuminates the MIL and sets a DTC.

MONITOR STRATEGY





TYPICAL ENABLING CONDITIONS





TYPICAL MALFUNCTION THRESHOLDS





COMPONENT OPERATING RANGE





CONFIRMATION DRIVING PATTERN

1. Connect the Techstream to the DLC3.

2. Turn the power switch on (IG) and turn the Techstream on.

3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

4. Turn the power switch off.

5. Turn the power switch on (READY) and turn the Techstream on.

6. Perform a universal trip.

7. With the shift lever in N, leave the vehicle until SOC drops to 30%.

HINT
Although DTC P3000 (INF 388) may be stored if the SOC drops to 20% or lower, this is not a malfunction.

8. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

9. Check that permanent DTCs are cleared.

HINT
- If the permanent DTC is not cleared, repeat steps 6 and 7.
- If a permanent DTC is output, the system is malfunctioning.
- If no permanent DTC is output, the system is normal.

INSPECTION PROCEDURE

PROCEDURE

1. CHECK FOR DTCS (DTC P0A1F-123 OR P0AFC-123 IS OUTPUT)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

(d) Check if DTCs are output.

Result





B -- GO TO DTC CHART (P0A1F-123 OR P0AFC-123) Hybrid Battery System
A -- Continue to next step.

2. CHECK BATTERY SMART UNIT P0A7F

B -- REPLACE HV BATTERY Removal

A -- REPLACE BATTERY SMART UNIT Removal