Installation

SEAT: REAR SEAT ASSEMBLY (for Power Seat): INSTALLATION

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

NOTICE:
If the position control ECU and rear seat adjuster is replaced, or the initialization cancel operation is performed, the position sensor initialization must be performed Rear Power Seat Control System.

HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL REAR SEATBACK ADJUSTER ASSEMBLY RH

HINT
Use the same procedures described for the LH side.

2. INSTALL REAR SEATBACK ADJUSTER ASSEMBLY LH





(a) Install the seatback adjuster with the 4 nuts.

Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

NOTICE:
Be careful not to damage the vehicle body.

3. INSTALL REAR NO. 1 SEAT ADJUSTER ASSEMBLY

HINT
Use the same procedures described for the No. 2 seat adjuster.

4. INSTALL REAR NO. 2 SEAT ADJUSTER ASSEMBLY





(a) Install the seat adjuster with the 4 bolts and nut.

for bolt A - Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

for except bolt A - Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

NOTICE:
Be careful not to damage the vehicle body.

(b) Install the air duct to the vehicle body.

5. CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY





(a) Connect the anchor part of the rear center seat outer belt with the nut.

Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

NOTICE:
Do not allow the anchor part of the rear center seat outer belt assembly to overlap the protruding part of the anchor bracket.

6. INSTALL REAR CENTER SEATBACK ASSEMBLY

(a) Connect the 2 connectors.





(b) Install the seatback center with the 2 bolts and nut.

Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

NOTICE:
Be careful not to damage the vehicle body.

(c) Attach the hook to the wire. Then attach the 2 clips to install the rear seat armrest hole board.





(d) While pressing the button, lower the headrest.





(e) Raise the center armrest.

7. INSTALL REAR SEATBACK ASSEMBLY RH

HINT
Use the same procedures described for the LH side.

8. INSTALL REAR SEATBACK ASSEMBLY LH

(a) Install the rear seatback assembly to the rear seat reclining adjuster assembly.

NOTICE:
Be careful not to damage the vehicle body.





(b) Lift the lower part of the rear seatback assembly towards the front of the vehicle, and connect the air duct to the vehicle.





(c) Connect the rear seatback assembly to the rear No. 2 seat adjuster. Then install the rear seatback assembly with the 2 nuts.

Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

(d) Install the rear clip on the top of the seatback, and attach the 3 pieces of fastening tape.





(e) Connect the connectors and 7 wire harness clamps.





(f) Connect the 2 connectors.





(g) Install the connector holder with the bolt.

(h) Install the seat belt to the seat belt guide.





(i) Attach the 2 claws.

(j) Install the floor end of the rear seat outer belt assembly with the bolt.





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

NOTICE:
Do not allow the anchor part of the rear seat 3 point type belt assembly to overlap the protruding parts of the floor panel.

9. INSTALL REAR CENTER SEAT CUSHION ASSEMBLY





(a) Attach the hook to install the seat cushion.

NOTICE:
Be careful not to damage the vehicle body.

10. INSTALL REAR SEAT CUSHION ASSEMBLY RH

HINT
Use the same procedures described for the LH side.

11. INSTALL REAR SEAT CUSHION ASSEMBLY LH





(a) Install the seat cushion.

NOTICE:
Be careful not to damage the vehicle body.

(b) Connect the connector.

(c) Attach the 2 front hooks of the seat cushion to the seat adjuster.

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

13. INSTALL BATTERY SERVICE HOLE COVER LH Installation

14. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire) Installation

15. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation

16. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.

17. CHECK REAR SEAT ASSEMBLY

(a) Check the power seat operation Operation Check.

(b) Check the climate control seat system Operation Check.

(c) Check the seat vibration system Operation Check.