Removal

2UR-FSE ENGINE CONTROL SYSTEM: THROTTLE BODY: REMOVAL

1. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

2. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY Removal

3. REMOVE NO. 1 AIR CLEANER INLET Removal

4. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH Removal

5. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH Removal

6. REMOVE NO. 1 ENGINE UNDER COVER Removal

7. DRAIN ENGINE COOLANT Service and Repair

8. REMOVE INTAKE AIR CONNECTOR PIPE





(a) Disconnect the No. 1 and No. 2 ventilation hoses from the intake air connector pipe.

(b) Using a clip remover, detach the wire harness clamp.

(c) Loosen the 3 hose clamps, and remove the intake air connector pipe.

9. REMOVE THROTTLE BODY ASSEMBLY





(a) Disconnect the throttle motor connector.

(b) Remove the 4 bolts and throttle body.

(c) Disconnect the No. 4 and No. 5 water by-pass hoses from the throttle body.





(d) Remove the gasket from the intake manifold.