Diagnostic Trouble Code (DTC) Index

DTC SOURCE ACTION

11 Disturbed or defective Go to Pinpoint Test Step
redundancy channel. Replace AA1.
anti-lock brake control
module if DTC repeats.

17 Reference voltage failure, Go to Pinpoint Test Step
caused by high/low battery BB1.
voltage, main power relay,
main fuse, wire harness, or
damaged anti-lock brake
control module.

18 Open or short Go to Pinpoint Test Step
circuit isolation valve #1 BB26.
or wire harness.

19 Open or short Go to Pinpoint Test Step
circuit isolation valve #2 BB29.
or wire harness.

22 Open or short circuit LH Go to Pinpoint Test Step
front inlet valve or wire BB2.
harness.

23 Open or short circuit LH Go to Pinpoint Test Step
front outlet valve or wire BB5.
harness.

24 Open or short circuit RH Go to Pinpoint Test Step
front inlet valve or wire BB8.
harness.

25 Open or short circuit RH Go to Pinpoint Test Step
front outlet valve or wire BB11.
harness.

26 Open or short circuit RH Go to Pinpoint Test Step
rear inlet valve or wire BB14.
harness.

27 Open or short circuit RH Go to Pinpoint Test Step
rear outlet valve or wire BB17.
harness.

28 Open or short circuit LH Go to Pinpoint Test Step
rear inlet valve or wire BB20.
harness.

29 Open or short circuit LH Go to Pinpoint Test Step
rear outlet valve or wire BB23.
harness.

31 Open circuit LH front Go to Pinpoint Test Step
sensor, wire harness, or CC1.
damage anti-lock brake
control module.

32 Open circuit RH front Go to Pinpoint Test Step
sensor, wire harness or CC8.
damaged anti-lock brake
control module.

33 Open circuit RH rear sensor Go to Pinpoint Test Step
, wire harness or damaged CC15.
anti-lock brake control
module.

34 Open circuit LH rear sensor Go to Pinpoint Test Step
, wire harness or damaged CC22.
anti-lock brake control
module.

35 Open or short circuit LH Go to Pinpoint Test Step
front sensor, wire harness, CC1.
damaged teeth on front
brake anti-lock sensor
indicator, sensor air gap
too small/large, damaged
anti-lock brake control
module.

36 Open or short circuit RH Go to Pinpoint Test Step
front sensor, wire harness, CC8.
damaged teeth on front
brake anti-lock sensor
indicator, sensor air gap
too small/large, damaged
anti-lock brake control
module.

37 Open or short circuit RH Go to Pinpoint Test Step
rear sensor, wire harness, CC15.
damaged teeth on front
brake anti-lock sensor
indicator, sensor air gap
too small/large, damaged
anti-lock brake control
module.

38 Open or short circuit LH Go to Pinpoint Test Step
rear sensor, wire harness, CC22.
damaged teeth on front
brake anti-lock sensor
indicator, sensor air gap
too small/large, damaged
anti-lock brake control
module.

41 Missing sensor signal LH Go to Pinpoint Test Step
front sensor (missing front CC1.
brake anti-lock sensor
indicator).

42 Missing sensor signal RH Go to Pinpoint Test Step
front sensor (missing front CC8.
brake anti-lock sensor
indicator).

43 Missing sensor signal RH Go to Pinpoint Test Step
rear sensor (missing front CC15.
brake anti-lock sensor
indicator).

44 Missing sensor signal LH Go to Pinpoint Test Step
rear sensor (missing front CC22.
brake anti-lock sensor
indicator).

55 Missing sensor signal LH Go to Pinpoint Test Step
front sensor (long term CC1.
failure).

56 Missing sensor signal RH Go to Pinpoint Test Step
front sensor (long term CC8.
failure).

57 Missing sensor signal RH Go to Pinpoint Test Step
rear sensor (long term CC15.
failure).

58 Missing sensor signal LH Go to Pinpoint Test Step
rear sensor (long term CC22.
failure).

61 Short circuit to ground. Go to Pinpoint Test Step
FLS #2 or wire harness. DD1.

62 Short circuit to ground. Go to Pinpoint Test Step
Anti-lock brake pedal DD1.
sensor switch or wire
harness.

63 No pump motor speed sensor Go to Pinpoint Test Step
signal during initial check DD7.
at 31 km/h (19mph), wire
harness or damaged anti
-lock brake control module.

64 Pump unable to build Go to Pinpoint Test Step
pressure during an ABS DD22.
stop.

67 Pump motor running not Go to Pinpoint Test Step
triggered by anti-lock E1.
brake control module.

75 Intermittent missing LH Go to Pinpoint Test Step
front sensor signal at CC1.
speeds below 40 km/h
(25mph).

76 Intermittent missing RH Go to Pinpoint Test Step
front sensor signal at CC8.
speeds below 40 km/h
(25mph).

77 Intermittent missing RH Go to Pinpoint Test Step
rear sensor signal at CC15.
speeds below 40 km/h
(25mph).

78 Intermittent missing LH Go to Pinpoint Test Step
rear sensor signal at CC22.
speeds below 40 km/h
(25mph).