Anti-Theft Security Access

NOTE:
^ The security access procedure is utilized to obtain PATS security access. PATS security access must be granted to erase ignition keys, enable/disable the spare key programming switch, or perform parameter resets for the Hybrid Electronic Cluster (HEC). The security access procedure invokes an inherent ten-minute time delay prior to granting security access during which scan tool must remain connected to the vehicle. Once security access has been granted, a security access command menu is displayed which offers various command options (refer to PATS Configuration Command Index). PATS Configuration Command Index
^ Select only the commands required by the appropriate pinpoint test.

1. From scan tool: using the Service Card, select HEC. Enter SECURITY ACCESS PROCEDURE. This procedure will take ten minutes to perform, during which the ignition switch must be in RUN and the scan tool must be connected to the vehicle.
2. After the ten minute security access procedure has been completed, a new menu will be displayed with command options. Select only those functions required before exiting out of this menu. Once exited out of this menu, the security access procedure must be performed again to perform additional commands.