Retrieve/Clear Continuous DTC's

- This function will display intermittent and hard faults that occur during normal operation.
- Display continuous codes can be initiated at any time. Normal operation of the system stops when display continuous codes is activated. Note that C" will be displayed while in this mode.
- To enter continuous display, press the OFF and PANEL buttons simultaneously and then release and within two seconds press the AUTO button.
- To exit continuous displays, press FRONT DEFROST. This will exit and clear all DTCs. Press the floor button to exit without clearing DTCs set before the last ignition cycle.
- Always exit continuous display before powering the system down (system turned off).
- Intermittent DTCs are saved only after an ignition cycle.
- Intermittent DTCs will be deleted after 80 ignition switch ON cycles after the intermittent condition occurs.