Pinpoint Test Y: The Speed Control Indicator Is Never/Always On

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test Y: The Speed Control Indicator Is Never/Always On

Normal Operation

If equipped with adaptive cruise control, the Instrument Panel Cluster (IPC) receives the speed control set message from the Cruise-Control Module (C-CM) over the High Speed Controller Area Network (HS-CAN) communication bus. If not equipped with adaptive cruise control, the Instrument Panel Cluster (IPC) receives the speed control signal from the PCM over the HS-CAN communication bus. When the speed control is engaged, the PCM or C-CM sends a message to the IPC to illuminate the speed control indicator. If the speed control message is missing for more than 5 seconds, the IPC sets DTC U0100:00 (without adaptive cruise control) or U0104:00 (with adaptive cruise control) in continuous memory and defaults the speed control indicator off.

NOTE: If DTC U0100:00 is set in the IPC, other observable symptoms may be an inoperative speedometer, tachometer or odometer.

This pinpoint test is intended to diagnose the following:

- PCM
- C-CM
- IPC



PINPOINT TEST Y: THE SPEED CONTROL INDICATOR IS NEVER/ALWAYS ON

-------------------------------------------------
Y1 CHECK THE SPEED CONTROL OPERATION


- Check the speed control system for correct operation.
- Does the speed control operate correctly?

Yes
GO to Y2.

No
REFER to Cruise Control.

-------------------------------------------------
Y2 CARRY OUT THE IPC INDICATOR LAMP CONTROL ACTIVE COMMAND USING THE SCAN TOOL


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IPC DataLogger.
- Select the IPC speed control indicator (CRUISE) active command. Command the speed control indicator on and off while observing the speed control indicator.
- Does the speed control indicator illuminate when commanded on, and turn off when commanded off?

Yes
GO to Y3.

No
INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) Instrument Panel Cluster (IPC). TEST the system for normal operation.

-------------------------------------------------
Y3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST


- Check for recorded DTCs from the IPC self-test.
- Are any DTCs recorded?

Yes
For DTC U0100:00, Go To Pinpoint Test AO. Pinpoint Tests AO: DTC U0100:00

For DTC U0104:00, Go To Pinpoint Test AQ. Pinpoint Tests AQ: DTC U0104:00

For all other DTCs, REFER to DTC Charts. Instrumentation, Message Center and Warning Chimes

No
For vehicles with adaptive cruise control, INSTALL a new C-CM. TEST the system for normal operation.

For vehicles without adaptive cruise control, INSTALL a new PCM. TEST the system for normal operation.

-------------------------------------------------