Operation CHARM: Car repair manuals for everyone.

Seat - Front




Seat - Front









Removal

WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.

WARNING: Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

NOTE: Driver shown, passenger similar.

1. Position the seat for access to all mounting fasteners and depower the Supplemental Restraint System (SRS). For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures of Air Bag Systems.

2. Remove the 2 rear seat track-to-floor nut covers.

3. Remove the 2 rear seat track-to-floor nuts.
- The center safety belt buckle anchor can be separated from the seat track once the seat is removed.

4. Remove the 2 front seat track-to-floor bolt covers.

5. Remove the 2 front seat track-to-floor bolts.

6. Disconnect the electrical connectors.





7. NOTICE: Use care when handling the seat. Dropping or sitting on a seat not secured in the vehicle may result in damaged components.

Remove the seat.

Installation

1. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

Install the seat in the vehicle.

- While installing, position the center safety belt buckle anchor to the rear inboard mounting area of the seat track and to the seat mounting stud.

2. Connect the electrical connectors.





3. Install the 2 front seat track-to-floor bolts.
- Tighten to 25 Nm (18 lb-ft).

4. Install the 2 front seat track covers.

5. Install the inboard seat track-to-floor nut.
- Before installing the rear inboard nut, make sure the center seat safety belt buckle anchor is correctly positioned to the seat track and seat mounting stud.

- Tighten to 80 Nm (59 lb-ft).

6. Install the outboard seat track-to-floor nut.
- Tighten to 25 Nm (18 lb-ft).

7. Install the 2 front seat track rear covers.

8. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures of Air Bag Systems.