Console - Floor

Console - Floor

Trim Panels, Mouldings and Fasteners

NOTE: Click here or refer to the on-line diagnostic/repair information to view this illustration as an interactive exploded view, requires Adobe(R) Acrobat(R) 8.0 or higher.

NOTE: Click here or refer to the on-line diagnostic/repair information to learn about using an Interactive Illustration.

NOTE: Floor console with navigation shown, floor console without navigation similar.











Trim Panels and Fasteners

NOTE: Click here or refer to the on-line diagnostic/repair information to view this illustration as an interactive exploded view, requires Adobe(R) Acrobat(R) 8.0 or higher.

NOTE: Click here or refer to the on-line diagnostic/repair information to learn about using an Interactive Illustration.

NOTE: (R) Floor console with navigation shown, floor console without navigation similar.











Removal and Installation

All vehicles

1. Apply the parking brake.

2. Place the selector lever in the NEUTRAL position.

3. Position the front seats to the full rearward and downward positions.

4. NOTE: LH floor console lower trim panel shown, RH floor console lower trim panel similar.

Pull the middle and rear of the LH and RH floor console lower trim panels outward to release the retaining clips.





5. NOTICE: Damage to the floor console upper trim panels may occur if cardboard is not used to remove the floor console lower trim panels.

NOTE: LH floor console lower trim panel shown, RH floor console lower trim panel similar.

Position a piece of cardboard between the LH and RH floor console lower trim panels and the floor console.





6. Remove the LH floor console lower trim panel and cardboard simultaneously.

7. Remove the RH floor console lower trim panel and cardboard simultaneously.

8. Push the RH and LH floor console lower trim panels toward the front of the vehicle to detach the trim panel from the pin-type retainers.





9. Position the front seats forward.

10. Remove the 2 rear floor console bolts.

11. Position the front seats rearward.

12. Remove the 2 pushpin retainers and the 4 floor console bolts.

13. Remove the selector lever bezel. For additional information, refer to Automatic Transmission/Transaxle.

Without navigation

14. Remove the 6 HVAC module screws.





15. Remove the HVAC module.
- Disconnect the electrical connectors.

With navigation

16. Remove the 4 floor console front finish panel screws.





17. Remove the floor console front finish panel.

18. Remove the 2 HVAC module screws.





19. Remove the HVAC module.
- Disconnect the electrical connectors.

All vehicles

20. Detach the wire harness pin-type retainer from the floor console.

21. Disconnect the floor console bulkhead connector.





22. Remove the 2 floor console-to-instrument panel bolts.





23. Disconnect the selector lever cable from the selector lever.





24. Remove the selector cable from the selector lever cable bracket.
- Release the 2 selector cable retaining tabs and pull the selector lever upward.





25. Remove the floor console.
- Pull the floor console rearward to release the retaining clips from the instrument panel.

26. To install, reverse the removal procedure.
- To install, make sure to align the retaining clips to the adjacent retaining clip holes.