Pinpoint Test W: The Charging System Message Center Warning Indicator Is Never/Always On

Instrumentation, Message Center and Warning Chimes

Pinpoint Test W: The Charging System Message Center Warning Indicator Is Never/Always On

Normal Operation

The charging system message center warning indicator is controlled by the Instrument Panel Cluster (IPC) based upon data received from the PCM over the High Speed Controller Area Network (HS-CAN) communication bus.

If the charging system message is missing for less than 5 seconds, the charging system message center warning indicator remains in the last indication mode (on or off). If the charging system message is missing for more than 5 seconds, the IPC sets DTC U0100:00 in continuous memory and defaults the charging system message center warning indicator on.

NOTE: If DTC U0100:00 is set in the IPC, other observable symptoms may be an inoperative speedometer, tachometer or odometer.

This pinpoint test is intended to diagnose the following:

- Charging system concern
- PCM
- IPC



PINPOINT TEST W: THE CHARGING SYSTEM MESSAGE CENTER WARNING INDICATOR IS NEVER/ALWAYS ON

-------------------------------------------------
W1 CHECK THE MESSAGE CENTER WARNING INDICATOR FUNCTION


- Close all doors, hood and luggage compartment lid.
- Ignition ON.
- Open the driver door while monitoring the door ajar message center displays.
- Does the door ajar message center warning indicator display?

Yes
GO to W2.

No
INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) Instrument Panel Cluster (IPC). TEST the system for normal operation.

-------------------------------------------------
W2 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO SELF-TEST


- Check for recorded PCM DTCs from the Key ON Engine OFF (KOEO) self-test.
- Are any charging system DTCs recorded?

Yes
REFER to Charging System.

No
GO to W3.

-------------------------------------------------
W3 CHECK THE CHARGING SYSTEM OPERATION


- Check the charging system operation. Refer to Charging System.
- Does the charging system operate correctly?

Yes
GO to W4.

No
REFER to Charging System.

-------------------------------------------------
W4 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST


- Check for recorded DTCs from the IPC self-test.
- Is DTC U0100:00 recorded?

Yes
GO to Pinpoint Test AQ. Pinpoint Tests AQ: DTC U0100:00

No
INSTALL a new PCM. REFER to Computers and Control Systems. TEST the system for normal operation.

-------------------------------------------------