Battery Cable: Service and Repair

Battery Cables









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Disconnect the battery. For additional information, refer to Battery Disconnect Battery Disconnect.

3. Remove the nut and the engine cover.
- To install, tighten to 10 Nm (89 lb-in).

4. Remove the bolt and position the battery cable body ground terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

5. Release the 2 battery cable harness locators from the fenderwell.

6. Remove the nut and position the Battery Junction Box (BJB) cable terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

7. Remove the nut and position the generator B+ terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

8. Release the battery cable harness locator from the generator bracket.

9. Remove the nut and position the battery cable engine ground terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

10. Release the battery cable harness locator from the valve cover stud bolt.

11. Remove the starter terminal cover.

12. Remove the nut and position the starter solenoid positive terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

13. Remove the nut and position the starter solenoid wire terminal aside.
- To install, tighten to 6 Nm (53 lb-in).

14. Remove the battery cable harness.
- Release the 3 remaining battery cable harness locators.

15. To install, reverse the removal procedure.