Curtain Air Bag Module Removal/Installation

CURTAIN AIR BAG MODULE REMOVAL/INSTALLATION

WARNING:
- Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module. Air Bag System Service Warnings Air Bag System Service Cautions

1. Turn the ignition switch to the LOCK position.

2. Disconnect the negative battery cable and wait for 1 min or more.

3. Remove the following parts:
a. A-pillar lower trim A-Pillar Lower Trim Removal/Installation

b. A-pillar trim A-Pillar Trim Removal/Installation

c. Front scuff plate inner Front Scuff Plate Removal/Installation

d. Rear scuff plate inner Rear Scuff Plate Removal/Installation

e. B-pillar lower trim B-Pillar Lower Trim Removal/Installation

f. Front seat belt upper anchor installation bolt Front Seat Belt Removal/Installation

g. B-pillar upper trim B-Pillar Upper Trim Removal/Installation

h. Rear seat Rear Seat Removal/Installation

i. Sub trunk box Service and Repair

j. Trunk end trim Trunk End Trim Removal/Installation

k. Trunk side trim

l. C-pillar trim C-Pillar Trim Removal/Installation

m. D-pillar trim D-Pillar Trim Removal/Installation

n. Map light Service and Repair

o. Sunvisor Service and Repair

p. Assist handle Service and Repair

q. Headliner Service and Repair

r. Rear speaker Rear Speaker Removal/Installation

4. Remove in the order indicated in the table.










5. Install in the reverse order of removal.

6. When the ignition switch is turned to the ON position verify that the air bag system warning light illuminates for approx. 6 s and goes out.

- If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection of the system. Flowchart

Connector Removal Note

1. Using a flathead screwdriver, lift the locking device carefully, however do not remove it.






2. Disconnect the connector.