Initial Inspection and Diagnostic Overview

FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (L3 WITH TC)]

- If the CAN system is considered to be the cause of the malfunction based on the repair order form and the malfunctioning symptom, follow the.
- DTCs are also output due to a control module or sensor malfunction, or incorrect power supply. Verify the output DTCs and first inspect the DTCs not shown in DTC Table Multiplex Communication System.
- If there is an open circuit in the communication lines, it is possible that signal error DTCs may be output in addition to communication error DTCs. Perform Determining Malfunctioning Part (HS-CAN) - Multiplex Communication System , Determining Malfunctioning Part (MS-CAN) - Multiplex Communication System if the communication error and signal error DTCs are output simultaneously.

Troubleshooting Procedure





*1
DTC Table Multiplex Communication System
*2
U0001
*3
U0010
*4
Determining Malfunctioning Part (HS-CAN) - Multiplex Communication System / Determining Malfunctioning Part (MS-CAN) - Multiplex Communication System
*5
Scan Tool Testing and Procedures