Air Temperature Sensor ( Ambient / Intake ): Service and Repair

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR/BOOST AIR TEMPERATURE SENSOR REMOVAL/INSTALLATION [L3 WITH TC]

1. Disconnect the negative battery cable.

2. Remove the charge air cooler duct. (See Service and Repair.)

3. Remove the oil level gauge pipe. (See Service and Repair.)

4. Disconnect the MAP/boost air temperature sensor connector.

5. Remove MAP/boost air temperature sensor from the intake manifold.






6. Install in the reverse order of removal.

Tightening torque
- 5.0-7.0 Nm {51-71 kgf-cm, 45-61 in-lbf}