Front Suspension

FRONT SHOCK ABSORBER AND COIL SPRING REMOVAL/INSTALLATION

CAUTION:
- Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.

1. Remove the windshield wiper arm. Windshield Wiper Arm and Blade Removal/Installation

2. Remove the cowl grille. Cowl Grille Removal/Installation

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.

5. Inspect for front wheel alignment, and adjust it as necessary. Front Wheel Alignment










Front Shock Absorber and Coil Spring Installation Note

1. Install the front shock absorber and coil spring so that the identification mark on the mounting rubber is facing to the position indicated in the figure.






2. Install the steering knuckle to the shock absorber, insert the bolts from the direction shown as follows, then tighten them to the specified torque.

- Vehicle left side: Insert the bolts from the vehicle rear.
- Vehicle right side: Insert the bolts from the vehicle front.

Cap Installation Note

CAUTION:
- If the pad in the strut mount area is removed, clean the attachment surface and install the cap. If the cap is not installed, the front shock absorber may corrode due to water penetration and cause a malfunction.