Rear Door Window Glass: Service and Repair

REAR DOOR GLASS REMOVAL/INSTALLATION

1. Fully lower the rear door glass.

2. Remove the rear beltline molding. (See )

3. Remove the sail garnish. (See Sail Garnish Removal/Installation)

4. Remove the rear door garnish. (See )

5. To access the glass installation bolt, position the rear door glass so that the distance from the top of the rear door glass to the upper part of the rear beltline molding is approx. 140 mm {5.5 in}.






6. Disconnect the negative battery cable.

7. Remove the rear door trim. (See Removal and Replacement)

8. Remove the bolts.






9. Remove the rear door glass guide and glass run channel as a single unit.






10. Remove the hole cover.






11. Remove the bolt.

12. Lift the rear door glass up and remove it in the direction of the arrow.

13. Install in the reverse order of removal.