Operation CHARM: Car repair manuals for everyone.

Reading and Clearing Diagnostic Trouble Codes





ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [AW6A-EL, AW6AX-EL]

Reading DTCs Procedure

1. Connect the M-MDS (IDS) to the DLC-2.






2. After the vehicle is identified, select the following items from the initialization screen of the IDS.
a. Select "Self Test".

b. Select "Modules".

c. Select "TCM".

NOTE:
- Freeze frame data/snapshot data appears at the top of the help screen when the displayed DTC is selected.

Freeze frame data
- The freeze frame data consists of data for vehicle and transaxle control system operation conditions when malfunctions in the transaxle control system are detected and stored in the TCM.
- Freeze frame data is stored at the instant the malfunction indicator lamp illuminates, and only a part of the DTC data is stored.

Snapshot data
- The snap shot data stores the currently detected DTC data.
- The recording timing for the freeze frame data/snap shot data differs depending on the number of DTC drive cycles.

- For a DTC with a drive cycle number 1, only the malfunction determination data is recorded.
- For a DTC with a drive cycle number 2, both the malfunction determination and undetermined data is recorded.

Freeze frame data table

NOTE:
- Refer to PID monitor table for confirm the transaxle control system operation status while the TCM does not store the DTC. (See PID/Data Monitor Inspection)
- Freeze frame data items are not displayed, according to detected DTC.





Snapshot data table

NOTE:
- Refer to PID monitor table for confirm the transaxle control system operation status while the TCM does not store the DTC. (See PID/Data Monitor Inspection)
- Snapshot data items are not displayed, according to detected DTC.





3. Verify the DTC according to the directions on the screen.

- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection. Automatic Transmission/Transaxle - DTC Table

4. After completion of repairs, clear all DTCs stored in the TCM.

Clearing DTCs Procedure

1. Connect the M-MDS (IDS) to the DLC-2.






2. After the vehicle is identified, select the following items from the initialization screen of the IDS.
a. Select "Self Test".

b. Select "Modules".

c. Select "TCM".

3. Verify the DTC according to the directions on the screen.

4. Press the clear button on the DTC screen to clear the DTC.

5. Switch the ignition OFF (LOCK).

6. Switch the ignition ON and wait for 5 s or more.

7. Perform DTC inspection.

8. Verify that no DTCs are displayed.