Air Bag Control Module: Service and Repair

WARNING:
- Handling the SAS control module Improperly can accidentally deploy the air bag modules, which may seriously injure you. Read Restraint Systems Air Bag Systems Service Precautions Technician Safety Information Air Bag System Service Warnings before handling the SAS control module. (See Restraint Systems Air Bag Systems Service Precautions Technician Safety Information Air Bag System Service Warnings).Service Precautions





1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute to allow the backup power supply of the SAS control module to deplete its stored power.
3. Remove the dashboard. (See Body and Frame Interior Trim Dash Board Service and Repair).
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Turn the ignition switch to ON position.
7. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.
8. If the air bag system warning light remains on, off, or repeats flashing after servicing, there are malfunctions in the system. Carry out the inspection again. (See Restraint Systems Air Bag Systems Testing and Inspection Procedures).Testing and Inspection




Nut Installation
Note:
- Tighten the nuts in the order shown in the figure.