SAS Control Module

WARNING:
Handling the SAS control module Improperly can accidentally deploy the air bag modules, which may seriously Injure you. Read AIR BAG SYSTEM SERVICE WARNINGS before handling the SAS control module. (See AIR BAG SYSTEM SERVICE WARNINGS.) Service Precautions

1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute.
3. Remove the side walls.





4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Turn the ignition switch to ON position.
7. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.
If the air bag system warning light does not operate in the manner described, there are malfunctions in the system. Inspect the system using the on-board diagnostic function.

NOTE:
- When a new SAS control module has been installed, the air bag system warning light flashes continuously if there aren't any malfunctions in the system. Perform the air bag module deployment authorization procedure. (See AIR BAG MODULE DEPLOYMENT AUTHORIZATION PROCEDURE.) Service and Repair