Secondary Shutter Valve (SSV) Solenoid Valve Inspection

SECONDARY SHUTTER VALVE (SSV) SOLENOID VALVE INSPECTION
1. Disconnect the negative battery cable.
2. Remove the SSV solenoid valve.




3. Inspect for airflow using the steps in the table given.
- If it is normal, inspect related wiring harnesses.
- If there is any malfunction, replace the SSV solenoid valve.

Circuit Open/Short Inspection
1. Disconnect the PCM connector.




2. Inspect the given wiring harness for open or short (continuity check).

Open circuit
- If there is no continuity, the circuit is open. Repair or replace the harness.
- SSV solenoid valve terminal B (harness-side) and PCM terminal 1L
- SSV solenoid valve terminal A (harness-side) and main relay terminal C (harness-side)

Short circuit
- If there is continuity, the circuit is shorted. Repair or replace the harness.
- SSV solenoid valve terminal B (harness-side) and body GND
- SSV solenoid valve terminal A (harness-side) and power supply