No.17 Excessive Shift Shock From N to D or N to R Position/Range

NO.17 EXCESSIVE SHIFT SHOCK FROM N TO D OR N TO R POSITION/RANGE [SJ6A-EL]

No.17 Excessive Shift Shock From N to D or N to R Position/Range [SJ6A-EL]:

Step 1-Step 8:

Initial Learning

Warning:
^ When performing a initial learning, be aware of other vehicles, people, and other impediments to order to avoid an accident.

Note: While self-learning control gradually reduces shock during normal driving, initial learning is performed to initially learn a certain amount of driving conditions.

1. Warm-up
^ Increase the ATF temperature by leaving the vehicle idling or performing city driving. Verify that the ATF temperature is between 50-120°C (122-248°F). If the ATF temperature is outside this range, work to bring it inside the range.

Caution: Do not raise the ATF temperature by stalling the engine.

Note:
^ If the ATF temperature is not between 50-120°C (122-248°F), initial learning cannot be performed. Before learning, inspect for variable shift shock.

2. Gear shift control learning
^ In D range, with the throttle opening between 25-30%, drive until you reach 6th gear and a vehicle speed of 80 km/h (50 mph) or higher. Then, release the accelerator pedal and coast, and bring the vehicle to a stop in a least 60s. Repeat this procedure 10 times.
3. Inspect learning results
^ Verify that variable speed shock and shift shock have decreased compared to the conditions before learning.