PID/Data Monitor Inspection [FN4A-EL]

PID/DATA MONITOR INSPECTION [FN4A-EL]

1. Connect the M-MDS to the DLC-2.






2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

- When using the IDS (laptop PC)

- Select "DataLogger".
- Select "Modules".
- Select "PCM".

- When using the PDS (Pocket PC)

- Select "Module Tests".
- Select "PCM".
- Select "DataLogger".

3. Select the applicable PID from the PID table.

4. Verify the PID data according to the detections on the screen.

NOTE:
- Perform part inspection for the output device after PCM inspection.
- The PID/DATA MONITOR function monitors the calculated value of the input/output signals in the PCM. Therefore, if a monitored value of an output device is out of specification, it is necessary to inspect the monitored value of the input device related to the output device control. Since an output device malfunction is not directly indicated as a malfunction of the monitored value for the output device, it is necessary to inspect the output device individually using methods such as the simulation function.
PID/DATA MONITOR AND RECORD function table

PID/Data Monitor Table (Part 1):

PID/Data Monitor Table (Part 2):

*1
California emission regulation applicable mode
*2
Except for California emission regulation applicable mode

Simulation Function Procedure

1. Connect the M-MDS to the DLC-2.






2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

- When using the IDS (laptop PC)

- Select "DataLogger".
- Select "Modules".
- Select "PCM".

- When using the PDS (Pocket PC)

- Select "Module Tests".
- Select "PCM".
- Select "DataLogger".

3. Select the simulation items from the PID table.

4. Perform the simulation function, inspect the operations for each parts.

- If there is no operation sound from the solenoid after the simulation function inspection is performed, it is possible that there is an open or short circuit in the wiring harness, or solenoid, or sticking and operation malfunction.
Simulation item tableX: Available

Simulation Item Table:

*1
California emission regulation applicable mode
*2
Except for California emission regulation applicable mode