Control Valve Body Installation [FN4A-EL]

CONTROL VALVE BODY INSTALLATION [FN4A-EL]

On-Vehicle Installation

CAUTION:
- Be sure to align the parking rod and the manual valve.






1. Install the accumulator springs and accumulators into the transaxle case.










2. Install the control valve body component.






Tightening torque
- 7.8-10.8 Nm
{80-110 kgf-cm, 69.5-95.4 in-lbf}

Bolt length (measured from below the head)
- Mark B: 40 mm {1.575 in}
- No mark: 70 mm {2.756 in}

3. Install the oil strainer.

4. Match the harness colors, then connect the solenoid connectors and GND, and install the TFT sensor.










5. Install the GND.

Tightening torque
- 8-11 Nm {82-112 kgf-cm, 71-97 in-lbf}

6. Apply a light coat of silicon sealant to the contact surfaces of the oil pan and transaxle case.

7. Install the oil pan.






Tightening torque
- 6-8 Nm {62-81 kgf-cm, 53-70 in-lbf}

8. Install the under cover.

9. Connect the negative battery cable.

10. Install the battery duct and battery cover. Removal and Replacement

11. Add ATF and with the engine idling, inspect the ATF level. Automatic Transaxle Fluid (ATF) Replacement [FN4A-EL]

12. Perform the mechanical system test. FN4A-EL Transmission