Operation CHARM: Car repair manuals for everyone.

Passenger-Side Air Bag Module Removal/Installation




PASSENGER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION

WARNING:
- Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module. Air Bag System Service Warnings Air Bag System Service Cautions
- Due to the adoption of 2-step deployment control in the passenger-side air bag module, depending on the impact force, it is possible that inflator No.2 might not deploy. In such cases, before disposing of the air bag module, make sure to follow the inflator deployment procedures and verify complete deployment of inflators No.1 and 2.

1. Turn the ignition switch to the LOCK position.

2. Remove the battery cover. Removal and Replacement

3. Disconnect the negative battery cable and wait for 1 min or more.

4. Remove the following parts:
a. Side wall Side Wall Removal/Installation

b. Front console Front Console Removal/Installation

c. Front scuff plate inner Front Scuff Plate Removal/Installation

d. Front side trim Front Side Trim Removal/Installation

e. Glove compartment Service and Repair

f. Car-navigation unit (with car-navigation system) Service and Repair

5. Remove in the order indicated in the table.










6. Install in the reverse order of removal.

7. Turn the ignition switch to the ON position.

8. Verify that the air bag system warning light illuminates for approx. 6 s and then goes out.

- If the air bag system warning light does not operate, refer to the on-board diagnostic system (air bag system) and inspect the system. Flowchart

Passenger-side Air Bag Module Removal Note

1. Remove the passenger-side air bag module in the order indicated below.
a. Disengage the tab sliding the passenger-side air bag module upward.

b. Slide the passenger-side air bag module rearward.

c. Remove the passenger-side air bag module by pulling it outward and then down.






Connector Removal Note

1. Using a flathead screwdriver, lift the locking device carefully,.however do not remove it.






2. Disconnect the connector.