Shifter A/T: Service and Repair

SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION

1. Remove the battery cover, battery duct, battery, battery box, battery tray and PCM component. Removal and Replacement

2. Remove the air cleaner component. Service and Repair

3. Remove the side wall.

4. Remove the heat insulator (front and center).

5. Remove the selector lever knob and indicator component.

6. Remove the center console. Center Console Removal/Installation

7. Remove the rear blower motor. (Vehicle with rear blower unit.) Rear Blower Motor Removal/Installation [Full-Auto Air Conditioner]

8. Remove in the order indicated in the table.

9. Install in the reverse order of removal.










Selector Cable Removal Note

1. Remove the clip.

2. Remove the selector cable.






Selector Lever Component Installation Note

1. Tighten the nut in the order as shown in the figure.






Tightening torque
- 15.7-22.5 Nm {1.6-2.2 kgf-m, 11.6-16.5 ft-lbf}

Selector Cable Installation Note

1. Install the selector cable (selector lever component side) to the selector lever securely.

2. Install the selector cable (selector lever component side) to the selector lever bolt, and then temporarily tighten the nut.

3. Verify that the selector lever bolt end is exposed from the nut.






4. Verify that the selector lever is in the P position.

5. Verify that the manual shaft is in the P position.

CAUTION:
- Bending the selector cable in the manner shown in the figure will damage the cable and it may become loose when shifted. When installing the selector cable, hold it straight.






6. Install the selector cable (transaxle side) to the selector cable bracket securely.






7. Install the clip as shown in the figure.











NOTE:
- Install the selector cable to the manual shaft lever with the clip side of the selector cable end facing the front of the vehicle.

8. Install the selector cable to the manual shaft lever in such a way that the selector cable does not bear a load.

9. Verify that the manual shaft lever end is exposed from the selector cable end.

10. Install the nut completely so that no load acts on the selector lever.

Tightening torque
- 10-15 Nm {1.1-1.5 kgf-m, 7.4-11.0 ft-lbf}