Primary Control Valve Body Removal [FS5A-EL]

PRIMARY CONTROL VALVE BODY REMOVAL [FS5A-EL]

On-Vehicle Removal

WARNING:
- Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eyes whenever using compressed air.

CAUTION:
- Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents before removal.
- If any old sealant gets into the transaxle during installation of the oil pan, trouble may occur in the transaxle case and oil pan. Clean with cleaning fluids.

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable.

3. Remove the under cover.

4. Drain the ATF into a separate suitable container. Automatic Transaxle Fluid (ATF) Replacement [FS5A-EL]

5. Remove the oil pan.

6. Disconnect the solenoid valve connectors and ground.

7. Remove the oil strainer.






8. Remove the primary control valve body installation bolts as shown, then remove the primary control valve body component.






9. Remove the accumulators and accumulator springs.