Instrument Cluster Input/Output Check Mode

INSTRUMENT CLUSTER INPUT/OUTPUT CHECK MODE

NOTE:
- In this mode, it is possible to verify the items in the following chart.

Check Code Table

01-58:

NOTE:
- Check codes which are not listed may be indicated, but they cannot be inspected.

- The check codes are displayed in numerical order. (While performing the inspection, if you want to inspect a check code with a number smaller than the code number you are currently inspecting, terminate the check mode then repeat the inspection from the beginning.)

- If a speed signal is input to the instrument cluster (the wheels are rotated) while a code other than check code 50 or 51 is displayed, the input/output check mode will be cancelled.

- The check codes can be fast-forwarded by pushing and holding the odometer/tripmeter switch for 1 s or more.

Checking Order

NOTE:
- When inspecting more than two check codes, begin with the code with the highest ranking.

Check Code Inspection

Check code 01

Step 1-Step 2:

Check code 04

Step 1-Step 2:

Check code 08

Step 1-Step 2:

Check code 12

Check code 13

Check code 14

Check code 16

Check code 18

Check code 22

CAUTION:
- While inspecting with check code 22, the measured value is displayed in both odometer and tripmeter segments of the odometer/tripmeter. Verify both readings.

Step 1-Step 5:

Check code 23

Check code 25

Check code 26

Check code 31

Step 1-Step 2:

Check code 55

Step 1-Step 2:

Check code 58