Acceleration/Deceleration Sensor: Service and Repair

COMBINED SENSOR REMOVAL/INSTALLATION

CAUTION:
- The DSC may not function normally immediately after the combined sensor is replaced. After installation, always perform the initialization procedures for the combined sensor.
- The internal parts of the combined sensor could be damaged if dropped. Be careful not to drop the combined sensor. Replace the combined sensor if it is subjected to an impact. Also, do not use an impact wrench or other similar air tools when removing/installing the sensor.

1. Perform the following procedures:
a. Remove the front seat (RH). Removal and Replacement

b. Remove the audio amplifier. (With Bose(R)) Service and Repair

c. Remove the front scuff plate (RH). Front Scuff Plate Removal/Installation

d. Remove the front side trim (RH). Front Side Trim Removal/Installation

e. Remove the rear scuff plate (RH). Rear Scuff Plate Removal/Installation

f. Remove the B-pillar lower trim (RH). B-Pillar Lower Trim Removal/Installation

g. Remove the fastener A and fastener B.






2. Partially peel back the floor covering.

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.

5. After installation, perform the combined sensor initialization procedure. Programming and Relearning