Secondary Shutter Valve (SSV) Solenoid Valve Inspection

SECONDARY SHUTTER VALVE (SSV) SOLENOID VALVE INSPECTION [13B-MSP]

Airflow Inspection

1. Disconnect the negative battery cable.

2. Remove the SSV solenoid valve. Intake-Air System Removal/Installation

3. Inspect for airflow using the steps in the table below.











- If there is any malfunction, replace the SSV solenoid valve. Intake-Air System Removal/Installation
- If as specified, carry out the "Circuit Open/Short Inspection".

Circuit Open/Short Inspection

1. Disconnect the PCM connector. Service and Repair

2. Inspect the following wiring harnesses for open or short (continuity check).






Open circuit

- If there is no continuity, the circuit is open. Repair or replace the wiring harness.

- SSV solenoid valve terminal B and PCM terminal 2I
- SSV solenoid valve terminal A and main relay terminal C

Short circuit

- If there is no continuity, the circuit is shorted. Repair or replace the wiring harness.

- SSV solenoid valve terminal B and body GND
- SSV solenoid valve terminal A and power supply