Backup Lamp Switch: Service and Repair

BACK-UP LIGHT SWITCH REMOVAL/INSTALLATION [A26M-R]

1. Disconnect the negative battery cable.

2. Disconnect the back-up light switch connector.

3. Remove the aerodynamic under cover No.2. Aerodynamic Under Cover No.2 Removal/Installation

4. Remove the back-up light switch with the gasket.






5. Install a new gasket and the back-up light switch to the transaxle case.

Tightening torque
- 29-52 Nm {3.0-5.3 kgf-m, 22-38 ft-lbf}

6. Install the aerodynamic under cover No.2. Aerodynamic Under Cover No.2 Removal/Installation

7. Connect the back-up light switch connector.

8. Connect the negative battery cable.