Clutch Pedal Position Sensor / Switch: Testing and Inspection
CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION [13B-MSP]
NOTE:
- Before performing the following inspection, make sure to follow the troubleshooting flowchart. Initial Inspection and Diagnostic Overview
Continuity Inspection
1. Remove the battery cover. Removal and Replacement
2. Disconnect the negative battery cable.
3. Disconnect the CPP switch connector.
4. Verify that the continuity between CPP switch terminals B and D is as indicated in the table.
- If there is no malfunction, perform the "Circuit Open/Short Inspection".
- If there is any malfunction, replace the CPP switch. Service and Repair
Circuit Open/Short Inspection
1. Disconnect the PCM connector.
2. Disconnect the CPP switch connector.
3. Inspect the following wiring harnesses for open or short circuit. (Continuity inspection)
Open circuit
- If there is no continuity in the following wiring harnesses, there is an open circuit. Repair or replace the wiring harness.
- CPP switch terminal B and PCM terminal 1D
- CPP switch terminal D and body ground
Short circuit
- If there is continuity in the following wiring harnesses, there is a short circuit. Repair or replace the wiring harness.
- CPP switch terminal B and body ground
- CPP switch terminal B and power supply