Shock Absorbing Pad Removal/Installation

SHOCK ABSORBING PAD REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. A-pillar trim A-Pillar Trim Removal/Installation

b. Front scuff plate Front Scuff Plate Removal/Installation

c. Rear scuff plate Rear Scuff Plate Removal/Installation

d. B-pillar lower trim B-Pillar Lower Trim Removal/Installation

e. Front seat belt upper anchor installation bolt Front Seat Belt Removal/Installation

f. B-pillar upper trim B-Pillar Upper Trim Removal/Installation

g. Rear seat cushion Rear Seat Cushion Removal/Installation

h. Rear seat back Rear Seat Back Removal/Installation

i. Rear seat belt lower anchor installation bolt Rear Seat Belt Removal/Installation

j. Trunk end trim Service and Repair

k. Trunk side trim

l. C-pillar trim C-Pillar Trim Removal/Installation

m. Sunvisor Service and Repair

n. Rain sensor cover (Vehicles with auto light / wiper system) Service and Repair

o. Assist handle Service and Repair

p. Headliner Headliner Removal/Installation

3. Pinch the tab using pincers, remove clips A and B, then remove the shock-absorbing pad in the direction of the arrow shown in the figure.






4. Install in the reverse order of removal.