Rear Door Window Glass: Service and Repair

REAR DOOR GLASS REMOVAL/INSTALLATION

1. To access the glass installation bolt, adjust the position of the rear door glass that the height of the rear door glass towards the front is approx. 200 mm {7.87 in}.






2. Disconnect the negative battery cable.

3. Remove the sail inner garnish. Sail Inner Garnish Removal/Installation

4. Remove the rear door garnish.

5. Remove the rear door trim. Rear Door Trim Removal/Installation

6. Remove the rear door speaker. Rear Door Speaker Removal/Installation

7. Remove the rear door glass guide and glass run channel as a single unit.

8. Remove the hole cover A






9. Slightly bend back the hole cover B.






10. Remove the bolts.






CAUTION:
- If the bolts are removed without supporting the rear door glass, the rear door glass may fall off and be damaged. Remove the bolts while inserting your hand into the service hole to support the rear door glass.

11. Lift up the rear door glass, tilt it in the direction of arrow (1) shown in the figure, then remove it in the direction of arrow (2).






12. Install in the reverse order of removal.

CAUTION:
- If the bolts are removed without supporting the rear door glass, the rear door glass may fall off and be damaged. Remove the bolts while inserting your hand into the rear door speaker installation hole to support the rear door glass.





Rear Door Glass Guide Removal Note

1. Pull up the rear door weatherstrip and remove the screw.






2. Remove the bolt.

3. Slide the rear door glass guide in the direction of the arrow shown in the figure.






4. While rotating the rear door glass guide in the direction of the arrow shown in the figure, pull out the rear door glass guide and the glass run channel as a single unit from the rear door.