Hood Latch Release: Service and Repair

HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION

Hood latch

1. Open the hood.

2. Disconnect the negative battery cable. Removal and Replacement Removal and Replacement Removal and Replacement

3. Disconnect the hood latch switch connector. (vehicles with theft-deterrent system)






4. Remove the bolts.






5. Remove the hood latch.

6. Install in the reverse order of removal.

7. Adjust the hood. Adjustments

Hood release lever

1. Pull the hood release lever.






2. While maintaining the condition in procedure 1, insert a tape-wrapped flathead screwdriver as shown in the figure, press the ends of the tabs with the screwdriver in the direction of the arrows (1), pull the hood release lever in the direction of arrow (2), and then disconnect the lower panel.






CAUTION:
- Remove the hood release lever while being careful not to damage the hood release cable with the flathead screwdriver.

3. Pull the latch release lever outward, remove it from the lower panel, and then disconnect the hood release cable.






4. Install in the reverse order of removal.