Engine Control Module: Service and Repair

PCM REMOVAL/INSTALLATION [LF]

1. When replacing the PCM, perform the following:

- PCM configuration Programming and Relearning

2. Remove the battery cover.

3. Disconnect the negative battery cable. Removal and Replacement

4. Remove the air cleaner case. Service and Repair

5. Move the water hose from the PCM cover slightly out of the way.

6. Remove in the order indicated in the table.










7. Install in the reverse order of removal.

8. When replacing the PCM on the vehicles, perform the following:

- PCM parameter reset Keyless Entry System Advanced Keyless Entry And Start System

PCM Connector Connected Note

CAUTION:
- If the PCM connector is inserted at an angle and the lever is moved, the connector could be damaged. Verify that the PCM connector is inserted straight.





1. Verify that the PCM connector lever is tilted towards the wiring harness side as shown in the figure.






2. Insert the PCM connector straight until it contacts the PCM and verify that the lever reverts upward naturally.

3. Push the lever until a click is heard.