Diagnostic Trouble Code (DTC) Memory - Section 12
WARNING: Risk of Personal Injury!
Moving components
When working on components which are moved by band, by electric motor, by hydraulic or pneumatic means via a connecting mechanism, severe injury may be sustained as a result of severing, trapping or crushing of limbs.
During work in the area of the roll bar, there is a risk of serious injury should the roll bar suddenly deploy.
Extend the roll bar before working in the rollbar area. Keep parts of your body away from the range of travel of roll bar mechanism.
Refer to Hydraulic Test Program for additional Important safety warnings and precautions. Hydraulic Test Program
Prerequisite for reading DTC memory
1. Fuses OK.
2. Battery voltage > 11 V.
3. Connect HHT according to connection diagram, see section 0. Connection and Use of Test Equipment - Section 0
NOTE: The DTC's, actuations and actual values can be found under HHT menu for rollbar soft top control module.
The electronic ignition-starter switch (N73) serves as an interface (gateway) between the roll bar (RB) control module (power soft top) (N52) and the Hand-Held Tester (HHT).
Note regarding DTCs
Current diagnostic trouble codes are high lighted in black on the display. Additional detailed fault information based on fault type is displayed with nearly all diagnostic codes (DTC's) such as:
> Ohms resistance too great
< Ohms resistance too low
[]+ short circuit to positive (POS)
[]- short circuit to ground (GND)
-//- open circuit
Preliminary work:
Diagnosis - Function Test, Function Test - Section 11
