Side Impact Sensor - C-Pillar, RH

SIDE IMPACT SENSOR - C-PILLAR, RH







Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Vehicles equipped with second row bucket seats shown, vehicles equipped with a second row bench seat are similar.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.

1. Depower the system.
2. Remove the rear door scuff plate.
3. Remove the safety belt anchor bolt (if equipped).
- To install, tighten to 40 Nm (30 lb-ft).

4. Pull out on the quarter trim panel at the C-pillar to release the retaining clips and access the C-pillar side impact sensor.
- Separate the weatherstrip at the quarter trim panel.

5. Disconnect the side impact sensor electrical connector.
6. Remove the 2 side impact sensor bolts.
- To install, tighten to 12 Nm (9 lb-ft).

7. Remove the side impact sensor.

8. WARNING: The tightening torque of the side impact sensor retaining bolts is critical for correct system operation.

NOTE: Make sure the safety belt webbing is not twisted prior to installation.

To install, reverse the removal procedure.

9. Repower the system.
10. Check the active restraint system for correct operation.